Film Care and Maintenance Guide
Solar Control, Security, Privacy and Graphics Film applied to glass are fairly easy to care for and maintain. There are a few simple steps to ensuring that your film remains in top condition.
Solar Control Film
-
For general cleaning we recommend water with a mild detergent solution and a squeegee with a soft rubber blade.
-
Aerosol glass cleaners can be used but not ammonia-based cleaners.
-
To remove greasy marks use a mild detergent applied with a soft damp cloth or chamois.
Security Film
-
The tinted Safety/Security films can take up to 3 months to completely dry, especially in winter or if not in direct sunlight.
-
For general cleaning we recommend water with a mild detergent solution and a squeegee with a soft rubber blade.
-
Aerosol glass cleaners can be used but not ammonia-based cleaners.
-
To remove greasy marks use a mild detergent applied with a soft damp cloth or chamois.
Privacy and Graphics Film
-
We recommend cleaning with a damp cloth only because the film can be easily damaged with detergents and brushes.
General Care
-
Moisture between the film and the glass may cause a slight haze or milky appearance for several days after application. Don’t be concerned. It will disappear and the film will return to full clarity, although it may take 2-3 weeks to settle depending on atmospheric conditions.
-
Film requires a two week curing period. During this time you may notice bubbles in the application. Small bubbles can be expected to disappear without intervention, but if you notice any larger than a 20¢ coin please report these to us.
-
Please do not clean the newly applied film until 2 weeks after installation.
-
Do not use abrasive cloths, brushes or powders on the film.
-
Do not pick at the edges of the film. The small clear border around the edge ensures that the film is properly sealed and bonded to the glass. If the seal is broken the film may lift and will not re-adhere properly to the glass.
-
Do not apply ‘sticky tape’, pressure sensitive stickers or suction cup accessories to the glass after installation.
GUARANTEE
All films used by ALL PROTECTION TINTING carry a manufacturer’s warranty against any material fault. The terms of warranties vary with different films. In all cases, ALL PROTECTION TINTING offers a concurrent warranty on workmanship. Claims under guarantee are restricted to a maximum value of the original invoice. Warranty is void if the film has been subject to abuse or improper care. Warranties do not cover glass failure. Guarantees may not be changed except in writing by ALL PROTECTION TINTING.